Zinc Silicate Shop Primer

Zinc Silicate Shop Primer

Inorganic zinc silicate shop primer-Grey/Blue/Green/Red
Chat Now

Product Details


Product Description:

-- Model:725-E47

---A two pack zinc pigmented ethyl silicate shopprimer

--VOC less than 645g/L


Intended Uses:

-A shop primer for the protection of steel.

-Long term weathering protection.

-Good welding and cutting performances.

-Low health hazard.


Product Information:


Drying Information:


Overcoating Data:


Storage:

Store in cool and dry conditions,Well ventilate.Keep away from hot and fire. Shelf Life: 12 months

minimum at 25℃,Subject to re-inspection thereafter.


Pack Size:

Part A:20.5kg/10L in 20 L container

Part B:8.9kg/10L in 10 L container


Flash Point:

Part A:Greater than 14℃

Part B:Greater than 14℃

Mixed paint:Greater than 14


Systems and Compatibility:

Consult your Sunrui Representative for the systems best suited for the surfaces to be protected.


Surface Preparation:

1)High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. All surfaces to be coated should be clean, dry and free from contamination.

2)Steel surface should be prepared to Sa2.5GB/T 8923.1-2011, using automaticblasting/spraying equipment.

3)Steel grit or a mixture of steel grit of particle size 0.6-1.0mm and steel shot ofparticles size 0.6-1.4mm are normally used to give a appropriate coarseness.

4)Apply 725-E47 before oxidation occurs. If oxidation has occurred, the entireoxidized area should be reblasted to the standard specified above.


Limitations:

1)Drying time will depend on the substrate temperature and ventilation. If therelative humidity is below 50%, cure will be retarded.

2)725-E47 is not recommended for use as touch-up primer after fabrication.

3)Avoiding absorb the solvent steam and paint steam for long time. Skin and eyesmust avoid contacting the paint. Pay attention to ventilate and fireproof whenapplying.


Duty statement:

1)The data in the sheet base on the information from the laboratory and practice.

2)The application may exceed the control, so we only ensure our product quality.

3)We own the right of the data sheet modification without informing.



Inquiry