Most paints contain flammable solvents, and some also contain harmful substances which damage to the skin or swallowed / inhaled to health. While many countries have developed rules to regulate identification, storage and use of hazardous materials, but no the uniform international rules are reached today. Sunrui paint must control and prevent the occurrence of two kinds of risk during storage and application to reduce the risk to an acceptable level.
2, Explosion hazards during application. In certain concentrations, flammable solvents mix with oxygen in air can be ignition and explosion.
The following hazards levels are defined, and give preventive measures to be
taken under all conditions.
● General measures can be used:
● Regular, thorough washing hand with hot water or
● Rapid dressing wound
● Do not play cigarettes or eating with dirty hands
● Alert dust or salt spray caused by sanding abrasive or
● Check risks of fire or explosion carefully
● Check the place need for additional ventilation
Flash Point of
Paint is not Exceeding
Flash point of paint and solvent is described in our data sheets.
Flash point is the minimum temperature of the burn or
explode when the paint and air mixture reach a certain
If the air temperature close or above flash point, it is
necessary to reduce the solvent concentration to lower
explosion by providing enough ventilation
Solvent and other components in some paint will stimulate skin. While conventional paints may only cause tentative and minor infections, but Solvent and chemicals in some paint can cause inflammation of sensitive skin.
During the work, coat skin fat, wearing gloves, goggles,
and mask. It must be rid of the habit of wash with solvent.
Coat skin fat and wear protective gloves can avoid skin
contact with paint. If skin is accidentally contaminated by
paint, it should wash with cleanser and then use water to
Masks with filter core can filter dust, salt fog and mist.
Can consider the filter cartridge dust can also consider,
The function of filt dust and solvent can only be used in
solvent no obvious smell. If we can smell the odor of
solvent, it indicates that the filter has failed and must be
replaced with new filters. the working environment with
different risk levels must be equipped with appropriate
filters which noted in the mask and filter manufacturer.
Wear Fresh Air Masks
Harmful substances enter the body by the inhalation of
gas, vapor, dust or mist. Identification of jeopardize level
is called T.L.V, once known as the maximum allowable
concentration (M.A.C). Under the maximum allowable
concentration, a healthy painter can work eight hours
without adverse effects. The lower T.L.V, the more harmful substances.
Gas concentrations is describe as air (PPM) contained in
per cubic meter, solid concentration is describe as solid
dust (mg/m3) containd in per cubic meter. Our data sheets
show the minimum volume of a safe concentration level，but sometimes, the volume which reach 10% of the
lowest explosion limit is twenty times of the required air
volume. However in some work, there is no condition to
provide amount of air volume needed by paint shop. At
this time, it is particularly important for painter to equip
and mandatory to use fresh air masks or positive pressure
breathing apparatus to feed into the clean air. The mask
must match with the face.
Cover up hands as possible as you can, wear gloves and goggles. Avoid paint sticking to the skin. Provide good ventilation and wear fresh air masks. Immediately replaced coat and shoes after work. Dirty clothes and other items will be separated, remove dirt and wash clothes carefully. Wash hands thoroughly. Handling paint cans carefully, and prevent paint or toxic wastes pollute environment.