Epoxy Finish

Epoxy Finish

Epoxy finish-Multicolor
Chat Now

Product Details

Product Description:

---Model:725-H42-30

---A two pack epoxy finish.

---VOC less than 400g/L


Intended Uses:

--A tough cosmetic finish.

--For use in all above water areas

--For use at Newbuilding, Maintenance and Repair or On Board Maintenance.


Product Information:



Induction Period:



Drying Information:



Overcoating Data:



Storage:


Store in cool and dry conditions,Well ventilate.Keep away from hot and fire. Shelf Life: 12 months

minimum at 25℃,Subject to re-inspection thereafter.


Pack Size:

Part A: 22.8kg/14L in 20 L container

Part B: 5.7kg/6L in 6L container


Flash Point:

Part A:Greater than 31℃

Part B:Greater than 31℃

Mixed paint:Greater than 31℃


Systems and Compatibility:

Consult your Sunrui Representative for the systems best suited for the surfaces to be protected.


Surface Preparation:

High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. All surfaces to be coated should be clean, dry and free from contamination.


Newbuilding:

725-H42-30 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination.725-H42-30 must be applied within the coating interval specified (consult the relevant product data sheet). Areas of breakdown, damage etc. should be prepared to the specified standard (eg. St3) and primed prior to the application of 725-H42-30.


Repair/On Board Maintenance

725-H42-30 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination.725-H42-30 must be applied within the coating interval specified (consult the relevant product data sheet). Areas of breakdown, damage etc. should be prepared to the specified standard (eg. St3) and primed prior to the application of 725-H42-30.


Limitations:

1)725-H42-30 may be applied directly over aged 725-H42-30 following thorough fresh water washing and degreasing provided the coating to be       overcoated is in an intact and tightly adherent condition. 

2)Loose or flaking coatings should be removed back to a firm edge and 725-H42-30 or an appropriate primer should be used to repair the area before   application of the full coat.ambient curing temperature should be above 10℃.

3)Apply in good weather. Temperature of the surface to be coated must be least 3℃above the dew point when the humidity is lower than 85%.

4)In commom with all epoxy base coatings,725-H42-30will exhibit chalking of the film on UV exposure.

5)The dry time and overcoating interval may change according to the environment factors.


Duty statement:

1)The data in the sheet base on the information from the laboratory and practice.

2)The application may exceed the control, so we only ensure our product quality.

3)We own the right of the data sheet modification without informing.





Inquiry