Epoxy Finishing Marine Paint Cargo Hold Hull Coatings A Tough Consmetic

Epoxy Finishing Marine Paint Cargo Hold Hull Coatings A Tough Consmetic

Surface Preparation: 1. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. All surfaces to be coated should be clean, dry and free from contamination. 2....

Product Details

Surface Preparation:
1. High pressure fresh water wash or fresh water wash, as appropriate, and remove all oil or grease, soluble contaminants and other foreign matter in accordance with SSPC-SP1 solvent cleaning. All surfaces to be coated should be clean, dry and free from contamination.
2. Newbuilding/Major Refurbishment
725-H42-30 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination. 725-H42-30must be applied within the coating interval specified (consult the relevant and free from contamination. 725-H42-30 must be applied within the coating interval specified (consult the relevant product data sheet). Areas of breakdown, damage etc. Should be prepared to the specified standard (eg.St3) and primed prior to the application of 725-H42-30
3. Repair/On Board Maintenance
725C42-1 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination. 725-H42-30 must be applied within the coating interval specified (consult the relevant and free from contamination. 725-H42-30 must be applied within the coating interval specified(consult the relevant product data sheet). Areas of breakdown, damage etc. Should be prepared to the specified standard (eg.St3) and primed prior to the application of 725-H42-30
725-H42-30 Maybe applied directly over aged 725-H42-30 following thorough fresh water washing and degreasing provided the coating to be overcoated is in intact and tightly adherent condition. Loose or flaking coatings should be removed back to a firm edge and an appropriate primer should be used to repair the area before application of the full coat.

Limitations
a. This product will not cure adequately below 5°C。For maximum performance ambient curing temperature should be above 10°C
b. Apply in good weather, Temperature of the surface to be coated must be least 3°C above the dew point when the humidity is lower than 85%
c. Apply in good weather. Temperature of the surface to be coated must be least 3°C above the dew point when the is lower than 85%
d. In common with all epoxy base coatings, this product will exhibit chalking of the film on UV exposure.
e. The dry time and over coating interval may change according to the environment factors.
f. Avoiding absorb the solvent steam and paint steam for long time. Skin and eyes must avoid contacting the paint. Pay attention to ventilate and fireproof when applying.


Inquiry