725-N07-93 Wind turbine blade putty
Produce Description |
|
-A two pack polyaspartic ester putty, solvent free, giving excellent flexibility and adhesion for wind turbine blade. |
||||
Intended Uses |
|
- As putty for repairing the defects of FRP surface. |
||||
Product Information |
Volume Solids |
100% |
||||
Gloss Level |
Matt |
|||||
Typical Film Thickness |
1000μm(1000μm) 200 microns dry (273 microns wet) |
|||||
Theoretical Coverage |
1m²/liter at typical film thickness |
|||||
Mix ratio |
3.8:1(volume)6.4:1 (mass) |
|||||
Method of Application |
Knife |
|||||
Cleaner |
NX-501 |
|||||
Induction Period |
Not necessary |
|||||
Drying Information |
||||||
|
5℃ |
15℃ |
25℃ |
35℃ |
||
Touch Dry |
45min |
30min |
20min |
15min |
||
Hard Dry |
4.5h |
4h |
3h |
2.5h |
||
Pot Life |
70min |
60min |
45min |
30min |
||
Storage |
Store in cool and dry conditions. Well ventilate. Keep away from hot and fire. Shelf Life: 12 months minimum at 25℃Subject to reinspection thereafter |
|||||
Pack Size |
Part A |
6.4kg/3.3L in 6L container |
||||
|
Part B |
1kg/0.9L in 1L container |
||||
Flash Point |
Not available |
|||||
Surface Preparation |
Clean dust, grease, water droplets and other pollutants. Use mechanical grinding tools with 120 sandpaper to clean up the blade surface thoroughly. Grinding is required before any recoating. |
|||||
Limitations |
Apply in good weather. Temperature of the surface to be coated must be least 3℃ above the dew point when the is lower than 85%. The dry time and overcoating interval may change according to the environment factors. Avoiding absorb the solvent steam and paint steam for long time. Skin and eyes must avoid contacting the paint. Pay attention to ventilate and fireproof when applying. |
|||||
Duty statement |
The data in the sheet base on the information from the laboratory and practice. The application may exceed the control, so we only ensure our product quality. We own the right of the data sheet modification without informing. |