--A two component on rust and long term anticorrosive maintenance coating.
--Suitable for application at low temperature.
--VOC less than 90g/L.
--For use on steel surface which can not be blasted or steel surface which is wet or underwater.--For use at building, chemical plant, paper mill,bridge approach, etc.
Typical Film Thickness
500microns dry (500microns wet)
2m2/L at typical film thickness
Mix Ratio: 3.2:1(volume)8:1(weight))
Method of Application
Tip size range:0.45-68mm
Not recommended. Use HX-501 only in exceptional circumstances (volume 5%)
Store in cool and dry conditions,Well ventilate.Keep away from hot and fire. Shelf Life: 12 months
minimum at 25 ℃,Subject to re-inspection thereafter.
Part A: 16kg/11.5L in 20 L container
Part B: 3.2kg/1.5L in 6L container
Part A: Greater than 31℃
Part B: Greater than 31℃
Mixed pant: Greater than 31℃
★High-pressure water jetting
705-H53-103 For immersion service, the surface to be coated should be blasted to St2with high-pressure water jet. The surface should be removed the attachments, rust etc, especially rust in steel pits.
★Hand or Power Tool Preparation
Hand or power tool clean to a minimum St2（GB/T8923.1-2011）.
Note, all scale must be removed.
1) This product will not cure adequately below -10℃. For maximum performance ambient curing temperature should be above -5℃.
2) Apply in good weather. Temperature of the surface to be coated must be least 3℃above the dew point when the humidity is lower than 85%.
3) Before overcoating 725-H53-103, it must be clean, dry and free of zinc salts.
4) 725-H53-103 Part A may cause some gas when the component was storage at high temperatures. Care should be taken when opening containers.
5) 725-H53-103 will react with acid or alkali solutions.
6) The dry time and overcoating interval may change according to the environment factors.
7) Avoiding absorb the solvent steam and paint steam for long time. Skin and eyes must avoid contacting the paint. Pay attention to ventilate and fireproof when applying.
● The data in the sheet base on the information from the laboratory and practice.
● The application may exceed the control, so we only ensure our product quality.
● We own the right of the data sheet modification without informing.