Alkyd Finish Coating

Alkyd Finish Coating

Alkyd Finish-Multicolor

Product Details

Product Description:


--One-component alkyd finish

--VOC less than 420g/L

--Obtain a low spread fireworks certificate from CCS.

(IMO FTPC part2&5)

Intended Uses:

--A cosmetic finish, for use in indoor or outdoor.

--For use at a little chemical corrosion part.

Product Information:

Drying Information: 

Overcoating Data:


Store in cool and dry conditions,Well ventilate.Keep away from hot and fire. Shelf Life: 12 months

minimum at 25℃,Subject to re-inspection thereafter.

Pack Size:22kg/18L in 20 L container

Flash Point:Greater than 28℃

Systems and Compatibility:

Consult your Sunrui Representative for the systems best suited for the surfaces to be protected.

Surface Preparation:

All surfaces to be coated should be clean, dry and free from contamination.

Primed Surfaces:

The primer surface should be dry free from all contamination and 725-C43-1must be applied within the overcoating intervals specified (consult the relevantproduct data sheet).

Areas of breakdown, damage etc., should be prepared to the specified standard (e.gSa2.5(GB/T 8923.1-2011)or Abrasive Blasting, or Power Tool Cleaning) and patchprimed prior to the application of 725-C43-1.


1)725-C43-1 should be applied over a recommended primer coating scheme. The primer surface should be clean, dry and free from contamination. Areas of breakdown, damage etc. should be prepared to the specified standard (eg. Sa2.5) and primed prior to the application of 725-C43-1.

2)725-C43-1may be applied directly over aged 725-C43-1 following thorough fresh water washing and degreasing provided the coating to be overcoated is in an intact and tightly adherent condition. Loose or flaking coatings should be removed back to a firm edge and an appropriate primer should be used to repair the area before application of the full coat.


1)725-C43-1 is not suitable for use on immersed areas.

2)Apply in good weather. Temperature of the surface to be coated must be least 3℃above the dew point when the humidity is lower than 85%.

3)The dry time and overcoating interval may change according to the environment factors.

4)Avoiding absorb the solvent steam and paint steam for long time. Skin and eyes must avoid contacting the paint. Pay attention to ventilate and fireproof when applying.

Duty statement:

●The data in the sheet base on the information from the laboratory and practice.

●The application may exceed the control, so we only ensure our product quality.

●We own the right of the data sheet modification without informing.


Hot Tags: alkyd finish coating, China, suppliers, manufacturers, factory, Asia, Africa, made in China

Send Inquiry

You Might Also Like